Some of you may recall my earlier post about a “homemade” 12VDC power cable for clean cab locomotive radios.
I have since gone further and developed and 3D printed a plug for these radios. A few people have reached out to me about reproducing them. I have decided to offer them for $25.00 shipped. USPS flat rate to the lower 48.
These will be rated for RX only due to the female pin sizes in the plug. They are a two part device. One part is the plug that goes into the female port of the radio and the second is the threaded locking mechanism.
They include a 3″ lead with a heat shrink crimp end. The blanks for your cord will be supplied.
If you are interested in one please contact me though the contact me page found here.